Basic Functioning; Power Led Not On; Test Led Never Turns Off - NETGEAR UTM9S Reference Manual
Prosecure unified threat management (utm) appliance
Hide thumbs
Also See for UTM9S:
- Quick start manual (16 pages) ,
- Integration manual (8 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Basic Functioning
Note:
For descriptions of all LEDs, see
UTM25, UTM50, and UTM150
UTM9S and Modules
After you turn on power to the UTM, verify that the following sequence of events
occurs:
1.
When power is first applied, verify that the Power LED is on.
2.
After approximately 2 minutes, verify that:
a. The Test LED is no longer lit.
b. The left LAN port LEDs are lit for any local ports that are connected.
c. The left WAN port LEDs are lit for any WAN ports that are connected.
If a port's left LED is lit, a link has been established to the connected device. If a port is
connected to a 1000 Mbps device, verify that the port's right LED is green. If the port
functions at 100 Mbps, the right LED is amber. If the port functions at 10 Mbps, the right
LED is off.
If any of these conditions do not occur, see the appropriate following section.
Power LED Not On
If the Power and other LEDs are off when your UTM is turned on, make sure that the power
cord is correctly connected to your UTM and that the power supply adapter is correctly
connected to a functioning power outlet.
If the error persists, you have a hardware problem and should contact NETGEAR technical
support.
Test LED Never Turns Off
When the UTM is powered on, the Test LED turns on for approximately 2 minutes and then
turns off when the UTM has completed its initialization. If the Test LED remains on, there is a
fault within the UTM.
If all LEDs are still on more than several minutes minute after power-up, do the
following:
•
Turn the power off, and then turn it on again to see if the UTM recovers.
•
Reset the UTM's configuration to factory default settings. Doing so sets the UTM's IP
address to 192.168.1.1. This procedure is explained in
and Password
ProSecure Unified Threat Management (UTM) Appliance
on page 28.
on page 498.
Troubleshooting and Using Online Support
LED Descriptions, UTM5, UTM10,
on page 27 or
LED Descriptions,
Restore the Default Configuration
492
Advertisement
Table of Contents
Troubleshooting
