Configure Advanced Radio Settings - NETGEAR UTM9S Reference Manual

2. Select the Enable WDS check box.
3. In the WPA Password field, enter a password between 8 and 63 characters.
4. Click Apply to save your settings.
5. Enter a MAC address of a peer in the MAC Address field.
6. Click Apply to add the MAC address to the WDS Peers table.
7. Repeat step 5 and
Address table.

To configure WDS on a peer:
1. Configure the same wireless security that you have configured on the UTM9S.
2. Enter the MAC address of the UTM9S's access point, which is displayed on the WDS
Configuration screen of the UTM9S.
3. Enter the same WPA password or WEP key that you have entered on the WDS
Configuration screen of the UTM9S.
Note: Make sure that you use the same wireless security configuration on
all WDS peers.

To remove one or more MAC addresses from the WDS Peers table:
1. In the WDS Peers table, select the check box to the left of each MAC address that you
want to delete, or click the Select All table button to select all MAC addresses.
2. Click the Delete table button.

Configure Advanced Radio Settings


To configure advanced radio settings:
1. Select Network Config > Wireless Settings > Radio Settings. The Radio Settings
screen displays (see
2. Click the Advanced option arrow in the upper right of the Radio Settings screen. The
Advanced Wireless screen displays:
ProSecure Unified Threat Management (UTM) Appliance
step 6 for any other MAC addresses that you want to add to the MAC
Figure 313 on page 531).
Wireless Module for the UTM9S
549