Configure The Xdsl Settings - NETGEAR UTM9S Reference Manual

4. Configure secondary WAN addresses on the WAN port (optional). Configure aliases for
the WAN port. See
5. Configure Dynamic DNS on the WAN port (optional). Configure your fully qualified
domain names during this phase (if required). See
6. Configure the WAN options (optional). Optionally, you can enable the WAN port to
respond to a ping, and you can change the factory default MTU size and port speed.
However, these are advanced features, and changing them is not usually required. See
Configure Advanced WAN Options
Each of these tasks is detailed separately in this appendix.
Note: For information about how to configure the WAN meter, see
the WAN Traffic Meter

Configure the xDSL Settings

Before you can configure the DSL Internet connection to your ISP, you need to configure the
ADSL or VDSL settings and, if required, the ATM multiplexing method. These settings are
usually provided by your ISP, but you can autodetect these settings.
Note: Autodetecting the DSL settings takes about 25 minutes.

To configure the xDSL settings:
1. Select Network Config > WAN Settings. The WAN screen displays (see
page 505).
2. Click the Edit button in the Action column of the SLOT-x interface. The SLOT-x ISP Settings
screen displays (see
3. Select the xDSL Settings option arrow. The xDLS Settings screen displays:
ProSecure Unified Threat Management (UTM) Appliance
Configure Secondary WAN Addresses
on page 526.
on page 419.
Figure 298 on page 506).
xDSL Module for the UTM9S
on page 521.
Configure Dynamic DNS
503
on page 523.
Enable
Figure 297 on