Connecting The Pedal Cord - Yamaha Arius YDP-135 Owner's Manual

6
Connect the pedal cord.
6-1 Insert the pedal cord plug to the [PEDAL] jack
from the rear.
6-2 Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
6-3 Use a vinyl tie to take up any slack in the pedal cord.
6-3
6-2

■ Connecting the pedal cord

Insert the pedal cord securely until the metal part of the
cord plug disappears from view. Otherwise, the pedal
may not function properly.
7
Connect the power adaptor to the unit.
7-1 Connect the DC plug of the power adaptor to the
DC IN jack, and loop any cord slack onto the cord
hook so that the plug will not be disconnected
accidentally.
CAUTION
Do not bend the cord tightly when you hang the cord on the
cord hook. Otherwise, a short-circuit or fire may result.
6-1
Insert the cord all the
way until the metal part
of the plug disappears
from view.
8
Set the adjuster.
Rotate the adjuster until it comes in firm contact with
the floor surface.
■ After completing the assembly, please
check the following.
• Are there any parts left over?
 Review the assembly procedure and correct any
errors.
• Is this instrument clear of doors and other movable
fixtures?
 Move the instrument to an appropriate location.
• Does this instrument make a rattling noise when you
shake it?
 Tighten all screws.
• Does the pedal box rattle or give way when you step
on the pedals?
 Turn the adjuster so that it is set firmly against the
floor.
• Are the pedal and power cords inserted securely into
the sockets?
 Check the connection.
• If the main unit creaks or is otherwise unsteady when
you play on the keyboard, refer to the assembly
diagrams and retighten all screws.
When moving the instrument after assembly, always
hold the bottom of the main unit.
Key cover
Hold here
Do not
hold here
CAUTION
Do not hold the key cover or top portion. Improper
handling can result in damage to the instrument or
personal injury.
YDP-135 Owner's Manual
Keyboard Stand Assembly
Top portion
Do not
hold here
33