[To Pedal] Jack; Connect The Pedal Cord - Yamaha ARIUS YDP-S34 Owner's Manual

Keyboard Stand Assembly
E
2-2
2-3
Secure the anti-fall brackets (
CAUTION
Be sure to attach the anti-fall brackets to the instrument, to
ensure stability. Failure to do so might result in damage to the
instrument or even injury.
3.
Secure C.
3-1
Securely tighten the screws on C that were
attached in Step 1-3.
3-2
Attach the caps (
D
4.
Mount A.
Be sure to place your hands at least 10 cm from
either end of A when positioning it.
At least 10 cm
D
Align the dowels on D and E with the
corresponding holes on the bottom of A.
32
YDP-S34 Owner's Manual
2-1, 2-4
B
2-2
7)
using the screws.
) to the head of the screws.
6
3-2
B
C
3-1
At least 10 cm
A
B E
CAUTION
• Be careful not to pinch your fingers or drop the unit.
• Make sure to keep your hands more than 10 cm distant from
the ends of A when positioning the unit, to avoid pinching
your fingers.
• Do not hold the keyboard in any position other than the
D
position shown in the illustration.
5.
Secure A.
5-1
Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2
Secure A by tightening the short screws
(6 x 16 mm) from the bottom.
E
6.

Connect the pedal cord.

6-1
Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
6-2
Securely wind the cord holder around the
pedal cord.
The cord holder is attached to D.
6-3
Use a vinyl tie (Step 1-1) to take up any
slack in the pedal cord.
5-1
A
Projection of A
A
5-2
3