Using The Cr-314 Remote Control - Arcam DiVA DV78 Handbook

Using the CR-314 remote control

Ensure that DVD mode is selected using the
toggle button. The 'DVD' LED above the
Dims or turns the DV78's display on or off. Turning the display off
generally gives a slight improvement in sound quality.
Pressing once turns the display off; twice dims the display.
DISP
To restore the display to full brightness, press
This button enables you to repeat a selected
section from the disc (see page 16).
Press to cycle through the repeat play options.
RPT
Fast play and Skip chapter/tracks
Play fast ( ) and Skip (
Pause ( ), Play ( ) and Stop ( ) (see page 11).
These buttons are described on the facing page.
DV78
12
CD/DVD
CD/DVD
CD/DVD
is lit briefly when DVD mode is selected.
DISP (display)
a third time.
DISP
A–B
RPT (repeat)
) chapters/tracks in both
directions (see page 11).
OPEN
Opens and closes the disc tray.
Playback control
Advanced controls
0–9 keypad
This allows direct access to individual tracks on audio CDs. To
button
select a track, press the corresponding keypad button followed
by
OK
For example, to play track 15, press
CD/DVD
CD DVD
CD
1 2 3
DVD
4 5 6
DISP
7 8 9
A-B
0
RPT CLEAR PROG
OK
OPEN
P
SUBT TITLE MENU
MODE
ZOOM AUDIO MEM RTN
ANGLE SETUP STATUS SRCH
CR-314
. For tracks greater than 9, enter the digits in sequence.
1 , then
Standby
Press to toggle the standby state of the DVD player.
Standby
Note that Arcam CD players are not controlled by this button.
CLEAR
Use within the 'Program' and 'Bookmark' menus to clear
CLEAR
a numeric field (see pages 16–17).
PROG (program)
You can program a selection of up to 20 chapters/tracks
from a disc to play in any order. Press
'Programme' menu (see pages 17 and 19).
Slow play
Press or on the remote control to play slow forward or
backwards. There are four speeds of slow playback: 1/5,
1/4, 1/3 and 1/2. Press the button repeatedly to cycle
through the different speeds. To resume normal playback
speed, press .
PLAY
Note that slow play does not apply to audio CDs.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and
menu pages. Confirm your selection with the
MUTE
Stops sound to the speaker outputs of certain Arcam amplifiers.
Volume +/–
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume (+/–) controls and
no effect on the audio output level of the DVD players.
NOTE: Remember to install the two AAA batteries supplied
before trying to use your remote control.
Do not place anything in front of the display area on the
DVD player (where the IR receiver is located), or the
remote control may not work.
5 , then OK .
to access the
PROG
OK button.
button have
MUTE