Using The Cr-314 Remote Control - Arcam DV88 Handbook

Using the CR-314 remote control

Ensure that DVD mode is selected using the
toggle button. The 'DVD' LED above the
Dims or turns the DV88's display on or off. Turning the display off
generally gives a slight improvement in sound quality.
Pressing once turns the display off; twice dims the display.
DISP
To restore the display to full brightness, press
This button enables you to repeat a selected
section from the disc (see page 13).
Press RPT to cycle through the repeat play options;
alternatively use the 'Play modes' menu.
Fast play and Skip chapter/tracks
Play fast ( ) and Skip (
Pause ( ), Play ( ) and Stop ( ) (see page 9).
Note that when a DVD disc menu is displayed, the playback
controls (including and
These buttons are described on the facing page.
DV88
10
CD/DVD
CD/DVD
CD/DVD
is lit briefl y when DVD mode is selected.
DISP (display)
a third time.
DISP
A–B
RPT (repeat)
) chapters/tracks in both
directions (see page 9).
OPEN
Opens and closes the disc tray.
Playback control
) duplicate the function of the
cursor pad and button.
OK
Advanced controls
0–9 keypad
This allows direct access to individual tracks on audio CDs. To
button
select a track, press the corresponding keypad button followed
by
OK
For example, to play track 15, press 1, then 5, then
CD/DVD REMOTE
CD DVD
CD
1 2 3
DVD
4 5 6
DISP
7 8 9
A-B
0
RPT CLEAR PROG
OK
OPEN
MUTE
P
SUBT TITLE MENU
MODE
ZOOM AUDIO MEM RTN
ANGLE SETUP STATUS SRCH
CR-314
. For tracks greater than 9, enter the digits in sequence.
Standby
Press Standby to toggle the standby state of the DVD player.
Note that Arcam CD players are not controlled by this button.
CLEAR
Use CLEAR within the 'Program' and 'Bookmark' menus to clear
a numeric fi eld (see pages 12–13).
PROG (program)
You can program a selection of up to 16 chapters/tracks from
a disc to play in any order. Press
menu (see page 12 and 14).
Slow play
Press or on the remote control to play slow forward
or backwards. There are six speeds of slow playback: 1/7,
1/6, 1/5, 1/4, 1/3 and 1/2. Press the button repeatedly
to cycle through the different speeds. To resume normal
playback speed, press
PLAY
Note that slow play does not apply to audio CDs.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and
menu pages. Confi rm your selection with the
MUTE
Stops sound to the speaker outputs of certain Arcam amplifi ers.
Volume +/–
Adjusts the volume on Arcam remote-controllable amplifi ers.
Note that the volume (+/–) controls and
effect on the audio output level of the DVD players.
NOTE: Remember to install the two AAA batteries supplied
before trying to use your remote control.
Do not place anything in front of the display area on the
DVD player (where the IR receiver is located), or the remote
control may not work.
.
OK
PROG to access the 'Program'
.
button.
OK
button have no
MUTE