Advertisement
B16566-R0-Ei171RF-ENG-UC
The Ei171RF is for use with the following Ei RadioLINK Smoke/Fire/Heat Alarms and Accessories.
Mains Multisensor/Smoke/Heat/Fire Alarms: Ei2110, Ei160RC & Ei140 Series Alarms in
conjunction with an Ei168RC RadioLINK Base.
Battery Powered Smoke / Heat Alarms: Ei3100RF, Ei3103RF, Ei3105RF, Ei405, Ei405TY, Ei605C
(with RF module), Ei605TYC (with RF module).
Deaf & Hearing Impaired RadioLINK Alarm System: Ei170RF.
Accessories:
Ei407 Manual Call Point, Ei410 Remote Control (portable), Ei411H Remote Control (wall mounted),
Ei428 Relay Module, Ei408 Switched Input Module.
This leaflet describes the installation of the Ei171RF and its integration into a total RadioLINK Fire
Alarm System, incorporating a choice of Smoke/Fire/Heat Alarms and Accessories.
N.B. It is essential that the Ei171RF is connected to the mains to preserve its one-week battery
standby. Leaving the unit operating without mains connected will completely deplete the battery and
possibly damage it. (If the Ei171RF is not being used for a prolonged period and cannot be left plugged
in to the mains, then disconnect the battery).
Location
The Strobe Module should normally be fixed such that the internal strobe light can be seen from the bed.
An additional strobe module can be then placed in any other living area of the house which can be readily
seen by the occupant. It has to be powered from the mains (230VAC) so a suitable socket or junction box
must be available to which it can be permanently connected.
The back-up battery in the Strobe Module must not be exposed to excessive heat such as sunshine,
heaters, fires or the like.
The associated RadioLINK Alarms and Accessories must be located and installed as described in
their own instruction leaflets.
Strobe Module Ei171RF
The battery must first be installed in the Strobe Module. Open the rear compartment by squeezing
together the two latches as shown in Figure 1b, and lifting the cover off.
Auxillary
Socket
Mounting
Screw
Holes
RadioLINK Fire Alarm Panel for
For use with RadioLINK Smoke Alarms
1. Connect battery plug & then plug in mains.
2. After installation, house code system by pressing
house code switch with a small screwdriver or simila
2/9/09
2:54 PM
1. INTRODUCTION
2. INSTALLATION
Conversion
Jack
Model: Ei170R
Deaf & Hard of Hearing
Figure 1a
Page 2
Squeeze
Here
Wire
Channels
for mains lead
(and accessories
if required)
Battery
Cover
Squeeze as shown to open
battery compartment
2
Squeeze
Here
Figure 1b
Advertisement
