Getting Started
After the initial selection you can change the user interface at any
Control Panel
time by pressing the F2 key to display the
, then dou-
User Interface Selection
ble-clicking on the
icon. This will display a
Neoware
dialog with the same options that are displayed in the
Interface Selection Wizard
.
Control Panel
Note: When changing the User Interface from the
,
you will be prompted to restart the thin client before the selection
can take effect.
Network Configuration
If your network uses a remote configuration service such as DHCP
(Dynamic Host Configuration Protocol), the thin client will automat-
ically configure itself for the network when you switch it on.
If your network does not use DHCP, or you need to enter network
settings manually, refer to the section "Network Configuration" on
page 39 for details.
Network Configuration
15