AMT Datasouth Fastmark 4600 PLUS Series User’s guide User Manual page 85

Thermal transfer barcode printer
Hide thumbs Also See for Fastmark 4600 PLUS Series User’s guide:
Table of Contents

Advertisement

After the cutter is installed, install media and ribbon.
1. Put the media end on the roller.
2. Close the TPH latch.
3. Hold the PAUSE button and turn on the printer.
4. Release the button when the cutter starts cutting.
5. After cutting, the printer will feed the label for 8 inches.
Note: The procedure above is for first time installation or after cutter jam.
Normally the procedure for loading the media through the cutter is:
1. Put the media end on the roller.
2. Close the TPH latch.
3. Turn on the printer.
4. Press the FEED button to feed the media end through the cutter.
85

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents