Advertisement
Configure the storage system using Navisphere Manager from the
Navisphere management station.
IMPORTANT The following steps summarize how to configure an
FC4700 storage system. For detailed instructions on each procedure,
refer to the EMC Navisphere Manager Administrator's Guide.
1. Select the FC4700 storage system you want to configure.
Optional FC4700 Software Installation
2. If you have Access Logix™, SnapView, or MirrorView software,
install them in the same non-disruptive software installation
(NDU). Refer to the option-specific documentation as
appropriate.
Make certain all software packages are committed. In
Navisphere Manager, check the Software tab of the Array
Properties selection for any software packages requiring a
COMMIT. Perform the commit if necessary.
Remote SP Agent Configuration
3. Specify any additional privileged users for each SP.
Storage-System Properties Setup
4. Set the general configuration properties — enable automatic
polling, automatic polling priority, and SP-A and SP-B statistics
logging.
5. Set the read and write cache memory properties for each SP.
6. Set the FC4700 cache properties.
7. If the FC4700 is running Access Logix, set the data access
property.
Make Switch or Host Connections
Step 7
Configure the FC4700 System
11
Advertisement
