Hdd Setup; Sensor Setup; Sensor - Honeywell HRDP4F250 User Manual

HDD Setup

Sensor Setup

Sensor

______________________________________________________________________________________________
Document 800-02471 Rev A
02/09
Disk Overwrite – ENABLE / DISABLE [Select the check box to enable the DVR
to write over old data when the hard drive is full].
Disk Full Warning – ENABLE/DISABLE [Enable Disk Full Warning for
notification when the HDD becomes full and HDD Overwrite is disabled].
Remain Time – 0~60 [Define the amount of remaining recording time to
trigger the Disk Full Warning].
Used Space – 80~99 [Define the percentage HDD used that triggers the Disk
Full Warning].
Disk Full Alarm – 0~8 [Define the relay that will trigger when the HDD is full].
Disk Full Buzzer – ENABLE/DISABLE [Enable a continuous buzzer to sound
for Disk Full Warning].
Disk Full Message – ENABLE/DISABLE [Enable a popup message to display
for Disk Full Warning].
Sensor – N/O / N/C [Set sensors to Normally Open or Normally Closed].
Alarm Out – OFF / ON [Set Relay switches to Off or On].
Note For more information, see the
Record > Motion/Event Configuration > Sensor section.
Performance Series DVR User Guide
73