Remote Software; Set Up A Remote Connection; Configuring The Dvr - Honeywell HRDP4F250 User Manual

Remote Software

Set Up a Remote Connection

Configuring the DVR

______________________________________________________________________________________________
Document 800-02471 Rev A
02/09
The administrator and up to eighteen additional users (four simultaneously)
can access the DVR remotely using software installed on a personal computer.
Press SETUP on the front of the DVR or remote control to log in.
1.
2. Select NETWORK > CLIENT CONFIGURATION (See the Client
Configuration section of this manual for more details).
Change port settings or write down current port settings.
3.
4. Select SAVE to save current settings.
5. Select NETWORK CONFIGURATION (see the Network Configuration
section of this manual for more details).
6. Enable or clear DHCP depending on the network (Ask the network
administrator for assistance).
If DHCP is cleared – define the IP address and additional network
7.
information.
8. If DHCP is enabled – write down the IP address supplied by the DVR
system.
Note If the DVR does not display the IP Address after setting DHCP to ON,
Select SAVE to change the network and open Network Configuration
again.
9. Select SAVE to save current settings.
Performance Series DVR User Guide
63