Table of Contents
Advertisement
English
Note on Using the Image Scanner
The printer uses the image scanner to read cards. Use a USB interface
because the image scanner requires it. If you use the optional UB series
interface, no image data can be obtained.
Inserting Cards
1.
Wait until the ID LED starts flashing.
2.
Insert the card straight with its read side facing the ink cartridge
cover, with the bottom of the card continuously touching the card slot
until it stops as shown in the picture below.
3.
When the card is pulled into the printer, release it immediately.
Note:
When the card is pulled into the printer, a part of it comes out of the card carrier
slit at the back of the printer. Be sure not to block this slit. Doing so may cause
incorrect reading of data.
4.
When the card is ejected and ID LED flashes again, pull the card
straight out of the slit.
Note:
Do not touch the card when it is being ejected. Doing so may cause distortion and
other problems with the image data.
Cleaning the Image Scanner
If the glass of the scanner gets soiled from ink or paper dust, the quality of
the image data may deteriorate. Follow these steps to clean the glass.
16 TM-J9000/J9100
➀
➁
Card carrier slit
Advertisement
Table of Contents
