Table of Contents
Advertisement
English
Inserting Checks
With the Non-Auto Sheet Feeder (Non-ASF) Model
1.
Wait until the VALIDATION/FEEDER LED starts flashing. Then, insert
the check straight with its face (the side on which magnetic characters
are printed) facing the front of the printer, continuously touching the
feeder guide with the bottom of the check until it stops as shown in
the picture below.
2.
When the check is pulled into the printer, release it immediately.
With the Auto Sheet Feeder (ASF) Model
With the ASF model printers, you can put up to 25 checks in the feeder
guide to be fed automatically. See "Attaching the Pocket (only for the ASF
model)" on page 5 for instructions on attaching the pocket, and then
insert the checks. As shown in the picture below, align the checks on the
right bottom corner before you insert them into the feeder guide.
Note:
Align the checks neatly on the bottom-right corner as shown in the image before
insertion so that they will be fed one by one. If the checks are inserted without
being aligned, the checks may not be fed at all, or a paper jam or incorrect feeding
of multiple checks may result.
Ejecting Checks
When a check is ejected and the VALIDATION/FEEDER LED flashes again,
remove the check.
14 TM-J9000/J9100
➀
➁
Advertisement
Table of Contents
