Table of Contents
Advertisement
English
2.
Make sure that the ejection lever is open. If it is closed, open it.
The ejection lever is open.
Note:
Be careful not to hurt your fingers on the lever edge.
3.
Position the pocket as shown in the picture below, and push it into the
printer until it clicks in place.
➀
4.
Unfold the stopper of the pocket as shown in the following picture.
Stopper
6 TM-J9000/J9100
➁
Insert the hooks on the four corners of the
pocket into the holes indicated with the
circles, and move the pocket into place.
The ejection lever is closed.
Advertisement
Table of Contents
