Table of Contents
Advertisement
When the CPU is installed, the lever should snap into place at the side
of the socket.
Note:
To remove a CPU, pull the lever out to the side a little
and raise it as far as it will go. Lift out the CPU chip.
2.6.2 CMOS clear (J1)
Warning:
To avoid damaging the computer, always turn off the
power supply before setting "Clear CMOS." Set the
jumper back to "3V Battery On" before turning on the
power supply.
Table 2-3: CMOS clear (J1)
* 3 V battery on
J1
* default setting
2.6.3 Buzzer enable/disable (J9)
Table 2-4: Buzzer enable/disable (J9)
J9
* default setting
3
2
1
* Enabled
Clear CMOS
3
2
1
Disabled
Chapter 2 Installation
15
Advertisement
Table of Contents
