Acer TM7300 Series Service Manual page 84

Table 2-2 82371AB Pin Descriptions (continued)
Name Type
CONFIG2 I
PWROK I
SPKR O
TEST# I
POWER AND GROUND PINS
VCC V
VCC (RTC) V
VCC (SUS) V
VCC (USB) V
VREF V
VSS V
VSS (USB) V
Major Chips Description
CONFIGURATION SELECT 2. This input signal is used to select the positive or
subtractive decode of FFFF0000h–FFFFFFFFh memory address range (top
64 Kbytes). If CONFIG[2]=0, the PIIX4 will positively decode this range. If
CONFIG[2]=1, the PIIX4 will decode this range with subtractive decode timings
only. The input value of this pin must be static and may not dynamically
change during system operations.
POWER OK. When asserted, PWROK is an indication to PIIX4 that power and
PCICLK have been stable for at least 1 ms. PWROK can be driven
asynchronously. When PWROK is negated, PIIX4 asserts CPURST, PCIRST#
and RSTDRV. When PWROK driven active (high), PIIX4 negates CPURST,
PCIRST#, and RSTDRV.
SPEAKER. The SPKR signal is the output of counter timer 2 and is internally
"ANDed" with Port 061h bit 1 to provide the Speaker Data Enable. This signal
drives an external speaker driver device, which in turn drives the ISA system
speaker.
During Reset: Low After Reset: Low During POS: Last State
TEST MODE SELECT. The test signal is used to select various test modes of
PIIX4. This signal must be pulled up to V
CORE VOLTAGE SUPPLY. These pins are the primary voltage supply for the
PIIX4 core and IO periphery and must be tied to 3.3V.
RTC WELL VOLTAGE SUPPLY. This pin is the supply voltage for the RTC
logic and must be tied to 3.3V.
SUSPEND WELL VOLTAGE SUPPLY. These pins are the primary voltage
supply for the PIIX4 suspend logic and IO signals and must be tied to 3.3V.
USB VOLTAGE SUPPLY. This pin is the supply voltage for the USB
input/output buffers and must be tied to 3.3V.
VOLTAGE REFERENCE. This pin is used to provide a 5V reference voltage
for 5V safe input buffers. VREF must be tied to 5V in a system requiring 5V
tolerance. In a 5V tolerant system, this signal must power up before or
simultaneous to VCC. It must power down after or simultaneous to VCC. In a
non-5V tolerant system (3.3V only), this signal can be tied directly to VCC.
There are then no sequencing requirements.
CORE GROUND. These pins are the primary ground for PIIX4.
USB GROUND. This pin is the ground for the USB input/output buffers.
Description
(SUS) for normal operation.
CC
2-27