Settings On Each Client - Yamaha MCX-2000 - MusicCAST Digital Audio Server Setup Manual

Settings on Each Client

1 Turn on the client.
The front panel display lights up, showing the initial screen, followed by a "Connecting..." message.
n
If the client display shows the current time without backlight, it's in sleep mode. If this is the case, press the center stick of the cursor controller. The
client wakes up and shows the above message.
2 The "Connecting..." message indicates the client is searching a MusicCAST server to establish a network connection.
At this point, however, we have not completed any network configuration. So, when the client display shows a network
icon, push the controller stick upward or downward to cancel the message. The client stops searching.
n
The wireless network icon doesn't appear on the MCX-C15 that supports only wired networking.
3 From Top Menu, select Setup > Network > Manual Setup.
From the above menu, select a parameter and set it up as needed.
n
You may perhaps choose manual configuration of network parameters just because you want to get on top of your MusicCAST network. It's,
however, not so practical with MusicCAST clients. They're designed to get appropriate parameter values during automatic registration process
(page 31), so manual configuration should be done to 'edit' retrieved settings according to your special needs.
Wireless network icon (no signal)
Wired network icon (no connection)
Manual Setup menu
MCX-2000 Owner's Manual
39