Front Panel Display; Screen Saver; Page Displayed At Power On - Yamaha MCX-2000 - MusicCAST Digital Audio Server Setup Manual

Front Panel Display

1 From the User Interface menu, select Front Panel Display.
2 Change each parameter value as needed.
1 Backlight
Make the display backlight either Bright or Dark.
2 Contrast
Set the display contrast as you can clearly see it (0-50; factory
setting: 25). Be sure that an extremely high or low value makes
your display hard to be seen.
3 Your change is reflected in real time. When you select
OK, the "Saving..." message is shown and new settings
are stored.

Page Displayed at Power ON

1 From the User Interface menu, select Page displayed at
Power ON.
2 You have just one parameter, Open the last page
displayed, for this setting. Select ON if you want the last
shown screen to be displayed when the MCX-2000 is
connected to the AC power source or waking up from
sleep or standby mode. Select OFF if you want the Top
Menu screen to be displayed (factory setting).
3 When you select OK, the "Saving..." message is shown.
The MCX-2000 afterward shows a screen as specified
here.
MCX-2000 Owner's Manual
94

Screen Saver

1 From the User Interface menu, select Screen Saver.
2 Change each parameter value as needed.
1 Use Screen Saver
Specify whether you use the screen saver. Select ON if you want
the screen display to go off after the specified duration even
while the MCX-2000 is active (factory setting). Select OFF if you
want the screen display to go off only when the MCX-2000
enters sleep or standby mode. If you select ON, specify the
duration with the following parameter (unavailable with OFF).
2 Delay before activation
Specify the duration of the screen display before the screen
saver is activated (1 minute ~ 60 minutes; factory setting: 10
minutes).
3 When you select OK, the "Saving..." message is shown.
The MCX-2000 afterward turns on and off the display as
specified here.
n When shipped, the MCX-2000 is set to activate the screen saver in 10
minutes. So, your TV monitor screen will automatically go off in 10
minutes after your last operation, even while the MCX-2000 continues
working and doesn't enter sleep mode. When you operate the
MCX-2000 at this point, the unit cancels the screen saver and
displays the last shown screen.