Yamaha MCX-2000 - MusicCAST Digital Audio Server Setup Manual page 12

3 Following the screen message, start Auto Configuration on each client. Use the front-panel cursor controller to select
Top Menu > Setup > Network > Auto Configuration, and then press the PLAY button. The clients start searching for the
music server (MCX-2000).
n
You can use the cursor controller on a client's front panel in the same way as the cursor controller on the MCX-2000 remote control. Push the
center stick upward, downward, leftward or rightward as you press the up, down, left or right arrow button on the remote control. When you
press this stick vertically, it works the same as pressing the SELECT button. In addition, you can go back to the previous screen by pushing the
stick leftward.
4 When you go to the next Easy Setup screen, the MCX-2000 starts searching for any available clients.
n
Don't touch or operate any clients until their IDs appear in the above screen and are successfully registered to the MCX-2000.
MCX-2000 Setup Guide
12
PUSH
SELECT
PUSH
SELECT
PUSH
SELECT
PLAY