A&D HW-10KGL Instruction Manual page 62

Zero
The current mass value is set to the zero point, this is same as the
Template
Command
Reply
Tare
The current mass value becomes zero after placing a tare (receptacle, case, etc)
and the net is displayed. This is same as the
Template
Command
Reply
Cancel of tare
The display value becomes the gross and the net mark is turned off. (The tare value
becomes zero.)
Template
Command
Reply
The tare value is set and the net is displayed. The net mark is displayed.
Template
Command
Reply
An upper limit value is stored.
Template
Command
Reply
A lower limit value is stored.
Template
Command
Reply
Caution The lower limit value must be less than the upper limit value.
HW-G OZIM v1a
Z
The mass value becomes zero and zero point mark is displayed.
T
The current mass value becomes zero and net mark is displayed.
CT
Gross is displayed and the net mark is turned off.
PT,[parameter]
Net is displayed.
HI,[parameter]
The upper limit value is stored.
LO, [parameter]
The lower limit value is stored.
HW-G Instruction Manual Page 60
switch .
TARE
switch.
ZERO