A&D HW-10KGL Instruction Manual page 46

Item Display
Automatic
turning off
Baud rate
Output mode
?
?
A
Comparator
Notes
The "#" shows factory settings.
The "near-zero" is within ±4 digits from zero point in the unit of kg.
HW-G OZIM v1a
Meaning and purpose
The type L scale is turned off after 5 minutes of no operation,
when displaying zero.
?
# Not used
Used?
Transmission rate of the serial interface (RS-232C/ 422/485).
?
# 2400bps
?
4800bps
?
9600bps
Mode selection for the serial interface (RS-232C/ 422/485).
# Stream mode. (Refer to "16.2 Stream Mode")
Command mode. (Refer to "16.3 Command Mode")
A data is output, when the
Auto-print +
When the display becomes a positive stable value above
near-zero, the scale outputs the data automatically. Next
output can be performed after the display becomes near-
zero or a negative value.
Auto-print +/-
When the display becomes a stable value outside near-zero,
the scale outputs the data automatically. Next output can be
performed after the display becomes near-zero.
At each finish of full/dribble batch function, the data is output.
Mode selection for the comparator
# Pressing the
current display value.
The scale always compares the display value.
Pressing the
display value when not near-zero.
The scale always compares the display value when not
A
near-zero.
HW-G Instruction Manual Page 44
PRINT
?
switch, the scale always compares the
SET
A
switch, the scale always compares the
SET
?
?
?
switch is pressed.
?
A
A
?
?
?