A&D HW-10KGL Instruction Manual page 15

Display and Symbols
Stability mark.
When the current weight value is not changing, this mark
is displayed. The reading may now be taken.
Zero point mark.
With nothing on the pan and pressing the
switch or with a mass on the pan and pressing the
ZERO
switch, this mark is displayed. The zero point is the
TARE
starting point to weighing.
Net mark.
After pressing the
show net weight is displayed
Preset tare mark.
When storing a tare with digital input this mark blinks.
Accumulation mark.
When using the accumulation function, this mark is
displayed.
Low battery mark for type L.
When the battery power is low this mark is displayed.
Replace with six new batteries.
Ready mark for the full/dribble batch function. This mark
shows:
ON The weighing value is within the zero-band.
OFF The full/dribble batch process is above the
zero-band.
Blinking The start or end of the full/dribble batch
process above the zero-band.
The comparator indicator.
Using the comparator function and comparing a weighing
value with the upper and lower limits, the result is
indicated.
Using the full/dribble batch function, the full flow gate
indicator is shown as OK, the dribble flow gate indicator as
HI and the zero band indicator as LO.
Example:- Display of zero (zero point).
With an empty weighing pan by pressing the
The Zero mark is displayed.
The stability mark is displayed.
HW-G Instruction Manual Page 13
Meaning
switch this mark is displayed to
TARE
switch:-
ZERO
HW-G OZIM v1a