Stream Mode; Name - A&D HW-10KGL Instruction Manual

RS-232C interface has the following two modes.

Stream mode

Command mode Controls the scale using commands from a computer.
It is necessary to set the parameters of the "Baud rate (
"Output mode (
There are option cables as follows:
AX-KO557A RS-232C cable, D-sub 25 pin, 2m
AX-KO1786-200 RS-232C cable, D-sub 9 pin, 2m
Transmission system EIA RS-232C
Transmission
Data format
Pin Connections
Circuit
HW-G OZIM v1a
Outputs data countinuously and can be used for printing data.
)", " Format (
Asynchronous, bi-directional, half-duplex
Baud rate: 2400, 4800, 9600 bps
Data: 7 bits
Parity: 1 bit, Even
Start bit 1 bit
Stop bit 1 bit
Code ASCII
Terminator
Pin No. Signal name
1 -
2 RXD
3 TXD
4 -
5 SG
6 -
7 DSR
HW-G Instruction Manual Page 48
)" in the function table in advance.
CR LF (CR: 0D[H], LF: 0A[H])
Direction Description
Input
Output
-
Output
)",
Receive data
Transmit data
Signal ground
Data set ready