Traffic (Optional) - Garmin GTN 750 Pilot's Manual

9.1.2.5
Foreword
The Traffic group selection from the Map Setup Page Menu allows you to
Getting
customize the display of traffic on the Map page. The Traffic function requires
Started
the installation of the appropriate traffic device. TIS and TAS cannot be displayed
Audio &
at the same time. If the aircraft has a TAS unit installed, the GTN unit will be
Xpdr Ctrl
configured for TAS. If no TAS unit is installed and a GTX Mode-S transponder is
Com/Nav
installed, the GTN unit will be configured for TIS. Coverage is limited to specific
areas as shown in the AIM. TAS data comes from a TAS unit such as a Garmin
FPL
GTS 800 or 820, Skywatch 497, KTA 810, or other unit. Coverage follows the
airplane. In the Navigation Map page setup you can select the maximum range
Direct-To
at which traffic symbols are shown. Once outside of the selected range, traffic
will be decluttered. The default values are shown in bold type.
Proc
Charts
Traffic Selection
Range
Wpt Info
Map Traffic
Restore Defaults
Traffic
Terrain
Weather
Nearest
Music
Utilities
System
Messages
Symbols
Appendix
9-20
Index

Traffic (Optional)

1 NM, 1.5 NM, 2.5 NM, 4 NM, 5 NM, 7.5 NM, 10 NM,
15 NM, 25 NM
All Traffic, PA/TA, TA Only
Returns values to original factory settings
Table 9-4 Map Page Traffic Display Options
Garmin GTN 725/750 Pilot's Guide
Display Result
190-01007-03 Rev. B