Points To Remember For All Procedures; Points To Remember For Localizer Or Vor-Based Approaches - Garmin GTN 750 Pilot's Manual

6.12
Foreword
• The GTN 7XX Map page is designed to complement your approach
Getting
plates and vastly improve situational awareness throughout the approach.
Started
However, you must always fly an approach as it appears on the approach plate.
Audio &
Xpdr Ctrl
• The active leg (or the portion of the approach currently in use) is depicted
in magenta on the Map Page. As you fly the approach, the GTN 7XX
Com/Nav
automatically sequences through each leg of the approach unless "SUSP"
appears at the annunciation bar at the bottom of the display. "SUSP"
FPL
indicates that automatic sequencing of approach waypoints is suspended on
the current leg and normally appears at holding patterns, upon crossing the
Direct-To
missed approach point (MAP), for Climb to Altitude legs, and for Hold to
Proc Altitude legs.
• For roll steering autopilots: roll steering is terminated when approach mode
Charts
is selected on the autopilot and is available once the missed approach is
initiated.
Wpt Info
• If Vectors-to-Final is activated while on the "FROM" side of the FAF, automatic
Map
waypoint sequencing is suspended and the SUSP annunciation will appear.
Automatic waypoint sequencing will resume once the aircraft is on the "TO"
Traffic
side of the FAF and within full-scale deflection.
• For all procedures, make sure to check the runway, transition, and all
Terrain
waypoints.
Weather
6.13
Nearest
• The default factory setting allows the CDI output to automatically switch
Music
from the GPS receiver to the LOC receiver. This may be changed to manual in
some installations. If the "ILS CDI Selection" setting is changed to "Manual",
Utilities
you must determine when to select "GPS" or "VLOC" guidance during the
approach. Remember, "VLOC" is required for the final course segment from
System
Final Approach Fix (FAF) to MAP.
Messages
NOTE: Installations with certain autopilots, such as the KAP 140 and
KFC225, do not allow automatic ILS CDI switching.
Symbols
NOTE: GPS phase of flight annunciations (LPV, ENR, etc.) are not applicable
to the external CDI (or HSI) when VLOC is active.
Appendix
6-18
Index

Points to Remember for All Procedures

Points to Remember for localizer or
VOR-based Approaches
Garmin GTN 725/750 Pilot's Guide 190-01007-03 Rev. B