Garmin GTN 750 Pilot's Manual page 357

16.4.1.5 CDI Scale Selection
The CDI source and ILS CDI Capture type may be selected manually or
automatically. The selected CDI Scale will be reflected in the annunciation bar at
the bottom of the display.
1. While viewing the System Setup page, touch the CDI Scale key
to allow automatic selection or to choose a CDI Scale manually.
2. Touch the ILS CDI Capture key to select automatic or manual.
This feature enables the unit to automatically switch from GPS
to VLOC on an ILS approach. See Procedures-ILS Approaches for
more detail on ILS approaches.
190-01007-03 Rev. B
Figure 16-19 Confirming Crossfill Selection
Figure 16-20 CDI Selection
Touch To Select 1 NM CDI
Scaling
Touch To Select Automatic
CDI Scaling
Figure 16-21 CDI Scale Selection
Garmin GTN 725/750 Pilot's Guide
Touch OK to Enable
Crossfill With Dual Units
Touch To Select CDI Scale
Touch To Select ILS CDI
Capture Type
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Music
Utilities
System
Messages
Symbols
Appendix
16-19
Index