Initial Power-Up - HP L1000 - 9000 - 0 MB RAM Installation Manual

Initial Power-up

The following section describes the process of applying power to the rp54xx Server and booting the system to
the UNIX Login prompt. The amount of time it takes to go through self-test then boot the system will vary
widely depending on hardware configuration. The following provides a "typical" procedure. Yours may vary
depending on software and hardware installed:
Step 1. Apply AC Power to the system console.
Step 2. Apply power to the rp54xx Server by turning the front panel switch to ON.
Chapter 3
Cabling and Power-Up
rp54xx Server Boot Process
Power Switch
(Under Cover)
79