HP L1000 - 9000 - 0 MB RAM Installation Manual page 47

Step 13. Use six, M5 x 12 screws (without washers) to attach the tray to the slides. Three screws are used to
attach each slide. Insert the screws through the slides, through the tray and tighten into the
threaded nuts located on the inside of the sides of the tray.
Step 14. From the bottom of the tray pull the plunger pin down and give it a 1/4 turn to hold it in place.
Step 15. Position the server on the tray aligning the plunger pins with the alignment holes in the chassis.
Step 16. Release the plunger pins to secure the server.
Chapter 2
Server Unpacking and Installation
Install Stand-Alone Server in a Cabinet
3 Pan Head
M5x12 T25 screws
on each side
47