Brother S-7200C Instruction Manual page 59

<-[]3[]・[]5[] specifications >
Turn the
machine pulley
to lower the
needle bar until
the hole is
visible.
<Resetting the grease consumption amount>
After the grease has been applied, carry out the following procedure to reset the grease consumption amount.
1. While pressing the
2. "GuCt" will appear in the display (1).
3. Press the end backtack key (5).
4. The indicator of the end backtack key (5) will illuminate and the display (1) will change to showing "xxx". ("xxx" represents
the amount of grease consumed.) For example, "100" means that 100% of the grease has been consumed.
5. Press the continuous backtack key (6) for 2 seconds or more.
6. The display (1) will change to " 0".
7. Press the thread wiper key (2). The display (1) will change to stitch number display mode and treadle operation will be
possible. (This completes the reset procedure.)
key (3) and the key (4) at the right end simultaneously, press the power ON switch.
<-[]5[]specifications >
4241M
1. Turn the power switch to "OFF".
2. Remove the screws and the set screws.
3. Apply grease to each of the holes until the grease
overflows slightly.
4. Tighten the screws and the set screws in order to push
the grease in.
5. Turn the machine pulley by hand to move the needle bar
up and down several times in order to disperse the
grease.
6. Use a cloth to wipe away any excess grease from around
the screws and set screws and from underneath needle
4243M
bar bush D.
7. Carry out the reset procedure given below.
S-7200C
11. CLEANING
4242M
2138M 2139M
52