Lubrication (-[]0[], []3[] Specifications) - Brother S-7200C Instruction Manual

3-3. Lubrication (-[]0[], []3[] specifications)

* If the sewing machine is -[]5[] specifications, it is a complete dry type machine, and so no lubrication is necessary.
Do not connect the power cord until lubrication has been completed, otherwise the machine may operate if the
treadle is depressed by mistake, which could result in injury.
Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get
into your eyes or onto your skin, otherwise inflammation can result.
Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vomiting and
diarrhea.
Keep the oil out of the reach of children.
When cutting the nozzle of the oil tank, hold the base of the nozzle securely.
If you hold the end of the nozzle, injury from the scissors may result.
CAUTION
1. Hold the base of the nozzle of the accessory oil tank (1),
2. Loosen and remove the nozzle, and then remove the seal
3. Tighten the nozzle.
4. Open the oil feeding pocket cover (3).
5. Insert the nozzle of the oil tank (1) deeply into the oil
6. Check that the oil gauge (6) comes to the upper reference
7. Close the oil feeding pocket cover (3).
<Lubrication oil replenishment interval>
Be sure to add more oil if the oil gauge (6) is below the lower
reference line.
Upper reference
line
Lower reference
line
4136M
S-7200C
The sewing machine should always be lubricated and the
oil supply replenished before it is used for the first time,
and also after long periods of non-use.
Use only the lubricating oil <Nippon Oil Corporation
Sewing Lube 10N; VG10> specified by Brother.
* If this type of lubricating oil is difficult to obtain, the
recommended oil to use is <Exxon Mobil Essotex SM10;
VG10>.
and use scissors to cut about half-way along the straight
section (A) of the nozzle.
(2).
feeding pocket (4), and then add about 120 ml of
lubricating oil.
line in the oil gauge window (5).
3. INSTALLATION
8