Download  Print this page

Applying Grease (-[]3[], []5[] Specifications*); The G50 Operation Panel]; When "greaseup" Appears...when Using The G50 Operation Panel] - Brother S-7200C Instruction Manual

Single needle direct drive straight lock stitcher with thread trimmer.
Hide thumbs

Advertisement

11. CLEANING

11-2. Applying grease (-[]3[], []5[] specifications*)

[When "GrEASEUP" appears...When using the G50 operation panel]

If "GrEASEUP" flashes on the main display (1) and a buzzer sounds when the power switch is turned on, it means that grease
needs to be applied. (The sewing machine will not operate at this time, even if the treadle is depressed.)
Apply grease as required, while referring to the following for details.
* If the sewing machine is of –[]0[] specifications, it is a minimum lubrication-type sewing machine, and so there is no need
to add grease.
<To continue sewing without applying grease>
1. Press the RESET key (2).
2. The main display (1) will change to stitch number display mode, and sewing will be possible when the treadle is
depressed.
NOTE
・ If you do not apply grease when the "GrEASEUP" notification flashes, the notification will continue to flash each time the
power is turned on until you reset the notification by carrying out the procedure on the following page.
・ If you continue to use the sewing machine after the "GrEASEUP" notification appears without applying grease (or
without carrying out the reset procedure), "
will be forcibly prevented from operating for safety reasons.
If this happens, apply grease and carry out the reset procedure.
* If you continue to use the sewing machine after carrying out the reset procedure but without applying grease,
problems with the sewing machine may result.
<Applying grease>
Use Brother-specified "Grease unit (SA8837-001)".
Using the tube
49
E100" will appear after a certain period of time and the sewing machine
S-7200C
4240M
4087M

Advertisement

Table of Contents

   Also See for Brother S-7200C

   Related Manuals for Brother S-7200C

Comments to this Manuals

Symbols: 0
Latest comments: