HP StorageWorks 7110 - Virtual Array Using Manual page 20

LOOPPAIR
Sets the controller loop pair.
Syntax
looppair [loop pair]
Description
This command sets the LOOPPAIR variable which is used to access JBOD LCCs and disks. The
LOOPPAIR variable along with the ENCLOSURE and SLOT variables identify the component of
interest.
The LOOPPAIR variable should always be set to a value of 255.
Examples
To set the loop pair to 255:
VADIAG> looppair 255
To display the current value of LOOPPAIR:
VADIAG> looppair
LoopPair: 255
LOOPPAIR
20