Brother KE-436C Instruction Manual page 61

11. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES
Memory switches (30 - 3F)
Turn the dial while pressing the STEP BACK switch to change the values.
Switch No.
Possible setting range
memo-30 1 - 999
memo-31 1 - 5
memo-32 3 - 7
memo-33 1 - 10
memo-34 1 - 5
memo-35 3 - 9
memo-36
memo-37 0 - 3
memo-38
memo-39 0 - 11
memo-3A 1 - 3
memo-3b 0 - 13
memo-3c 0 - 4
memo-3d
memo-3E
memo-3F
55
Units Initial value
Time until feed mechanism starts moving after work clamp
10ms 10
has lifted.
Changes the feed speed.
4
1 (Fast)
Changes the possible sewing speed for a given stitch length.
3 (Fast)
3
3 (2,500/3 mm), 4 (2,300/3 mm), 5 (2,000/3 mm),
6 (1,800/3 mm), 7 (1,200/3 mm)
Changes the feed timing.
7.5 5
1 (Fast)
Number of low-speed stitches sewn at 400 rpm at sewing
stitch 1
start.
Changes the sewing start speed for the number of stitches
100rpm 4
specified by memo-34.
Automatically corrects the gear speed when reading 2DD
disks.
0: No automatic correction
0 1: Read as BAS-311A data
2: Read as BAS-326A data
3: Read as BAS-341A, 342A data
ex. Read BAS-326A data by KE-436C
Changes the reference point for enlargement and reduction
using the operation panel.
0, 1: Center of work clamp,
2: Upper-left corner of work clamp,
3: Lower-left corner of work clamp,
0 4: Upper-right corner of work clamp,
5: Lower-right corner of work clamp, 6: Sewing start point,
7: Sewing end point, 8: Upper-left corner of sewing pattern,
9: Lower-left corner of sewing pattern,
10: Upper-right corner of sewing pattern,
11: Lower-right corner of sewing pattern
Changes the speed limit for the given sewing pitch when the
maximum speed remains constant.
1: Speed limit is increased for the given sewing pitch and the
2: Standard
3: Speed limit is decreased for the given sewing pitch and the
2
Note:
If sewing slippage occurs in places where a large sewing
pitch is used, reduce the setting to 3.
Furthermore, sewing slippage may occur in some cases if
setting 1 is used.
Changes the work clamp operating mode. (When set to "0",
the mode is selected according to the settings for DIP
0
switches A-1 and A-2.) Refer to "12. Setting the work clamp
mode" for details on the setting values.
Changes the path taken when moving from the machine
home position to the start position.
0
0: Across inside of work clamp, 1: Top-left, 2: Bottom-left,
3: Bottom-right, 4: Top-right
KE-436C
Explanation
5 (Slow)
7 (Slow)
5 (Standard)
sewing speed for that pitch is increased.
sewing speed for thet pitch is decreased.
10 (Slow)
Set memo-37=2.