Sewing; Before Starting Sewing; Sewing Operation - Brother KE-436C Instruction Manual

7. SEWING

Turn off the power switch at the following times, otherwise the machine may operate if the foot switch is depressed
by mistake, which could result in injury.
When threading the needle
When replacing the needle and bobbin
When not using the machine and when leaving the machine unattended
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.
Note:
At the time of shipment from the factory, this sewing machine is set to not detect needle up errors. If you would like needle
up errors to be detected, set memory switch No. 14 to ON.

7-1. Before starting sewing....

7-2. Sewing operation

2718Q
CAUTION
Check that the needle bar is at its highest position. Turn the
machine pulley so that the index mark (1) on the pulley is
between the marks (2) on the belt cover.
* If the machine is started while the index mark (1) is not
between these two marks (2), error message "E.22" will
be displayed.
(only when memory switch No.14 is on)
2462Q
1. Turn the power switch on.
(The power indicator on the operation panel will light.)
2. Insert the floppy disk (1).
3. Press the PRO. No. selection switch (2) to select the
desired program number.
4. Press R/W switch (3).
The floppy disk drive indicator will light and the
program no. display (4) will show a "P" while the data is
being read. When reading is completed, an alarm will
sound and the indicator will go out, then the program
no. display (4) will blink the program number.
2719Q
KE-436C
7. SEWING
34