Manufacturing Options - Intel S975XBX2 - Workstation Board Motherboard Specification

Table 1. Feature Summary (continued)
Expansion
Capabilities
Hardware Monitor
Subsystem
1.1.2

Manufacturing Options

Table 2 describes the manufacturing options. Not every manufacturing option is
available in all marketing channels. Please contact your Intel representative to
determine which manufacturing options are available to you.
Table 2. Manufacturing Options
AMT
ATAPI CD-ROM
Connector
Audio Subsystem
Auxiliary PCI
Express Graphics
Power Connector
Discrete SATA
RAID Controller
IEEE-1394a
Interface
MCH Fan Header
Processor Core
Power Connector
SCSI Hard Drive
LED Header
Trusted Platform
Module (TPM)
• Two PCI* Conventional bus add-in card connectors (SMBus routed to both PCI
Conventional bus add-in card connectors)
• One Primary PCI Express x16 (electrical x16 or x8) bus add-in card connector
• One Secondary PCI Express x16 (electrical x8) bus add-in card connector
• One PCI Express x16 (electrical x4) bus add-in card connector
• Hardware monitoring and fan control ASIC
• Voltage sense to detect out of range power supply voltages
• Thermal sense to detect out of range thermal values
• Three fan headers
• Three fan sense inputs used to monitor fan activity
• Fan speed control
• Support for Product Environmental Control Interface (PECI)
BIOS support for Intel ® Active Management Technology (Intel
A 1 x 4-pin ATAPI-style connector for connecting an internal ATAPI CD-ROM drive to
the audio mixer
• Intel High Definition Audio subsystem in 6-channel (5.1) audio subsystem with
three analog audio outputs using the Sigmatel 9227 audio codec
Provides required additional power when using high power (75 W or greater) add-in
cards in either or both the Secondary PCI Express x16 (electrical x8) and the PCI
Express x16 (electrical x4) bus add-in card connectors
• Marvell* 88SE6145 SATA RAID controller
• Four SATA connectors (in addition to the four SATA connectors on the ICH7-R
SATA interface)
IEEE-1394a controller and two IEEE-1394a connectors: one back panel connector
and one front-panel header
A 3-pin header for powering a fan for the Intel
(MCH)
One of the following connectors for providing +12 V power to the processor voltage
regulator:
• 2 x 4-pin (requires a power supply with a dual-rail 2 x 4 power cable). Boards
equipped with the 2 x 4-pin processor core power connector will also include
heatsinks in the processor voltage regulator area.
• 2 x 2-pin
Allows add-in hard drive controllers (SCSI or other) to use the same LED as the
onboard IDE controller
A component that enhances platform security
Product Description
® AMT)
®
82975X Memory Controller Hub
13