Installation Instructions - GE PV976NSS Owner's Manual & Installation Instructions

7 INSTALL DUCT COVERS
• Remove protective
plastic covering.
• Assemble duct covers
according to application.
NOTE: The inside duct cover has
vent holes on one end. The holes are
intended for use when the hood is
installed for recirculating purposes. Slide the upper
duct cover into the folded ends of the lower duct
cover.
• Place the decorative duct covers on top of the
hood.
Upper duct
cover
Lower
duct cover
Lower duct
cover seat
•
ceiling bracket.
• Secure with 2 screws to the duct cover bracket.
• Remove the packing material from the filter
opening.
• Locate the screw holes on the inside front edge
of the opening. Install 2 screws to secure the
lower duct cover to the hood.
49-80549-2

Installation Instructions

Mounting
screws
Duct cover bracket
Duct cover
attachment tabs
Screw holes
8 INSTALL METAL GREASE FILTER
• Remove the protective film on the grease filter.
NOTE: The charcoal filter is not required for this
installation.
• Fit the tabs at the end of the filter into the slots in
the left side of the filter opening. Lift up the right
side of the filter and push gently until the filter
locks into place. Make sure the filter lock is in the
closed position to secure the filter.
• To remove the filter, pull downward on the filter
lock to release.
9 FINALIZE INSTALLATION
• Check to be sure all tape and packaging materials
have been removed.
• Refer to the Operating Instructions in this manual
to operate the hood.
17