HP D7171A - NetServer - LPr Installation Manual page 9

3. Create a DOS partition (50MB) and install the CD-ROM drive for the DOS
environment as explained in "Installing the SCSI Drivers on NetWare 3.12"
above.
4. Remove the HP Navigator CD-ROM and insert the NetWare
4.11/IntranetWare CD-ROM
5. Change to CD-ROM drive by entering the logical drive letter you assigned to
your CD-ROM drive, for example:
E:
Then type:
Install
6. The NetWare 4.11/IntranetWare installation program has a special feature that
automatically detects system hardware (number of CPUs, controllers, LAN
cards) and the software drivers for accessory hardware. Follow the
instructions listed below that relates to the specific hardware installed in your
system:
Multi-Processor System:
If the installation program detects a multi-processor system, the sceen
will display:
Do you want to
NetWare (SMP)?
You can choose YES to install NetWare 4.11/IntranetWare SMP (free
with 4 processors maximum) or NO to install NetWare
4.11/IntranetWare.
If you install NetWare 4.11/IntranetWare SMP in your multi-processor
system, make sure that you use HP Navigator and run EISA Config to
set the MP SPEC. to 1.4.
Hard Disk Controllers, LAN Cards:
The installation program will AUTOMATICALLY DETECT all the
embedded SCSI controllers or SCSI cards and all the LAN cards, then
load the MOST APPROPRIATE drivers.
If a hard disk controller or a LAN card has more than 1 driver to support
it, the screen will display a message similar to:
Install found the following hardware but found more
than one driver supporting this hardware:
PCI.8080.1229.0000.0000.01
Press <Enter> for a list of drivers to choose from or
<F3> to continue without selecting
You should press <Enter> to select the right drivers for your cards.
After detecting all the existing disk controllers and LAN cards in the
system, the screen will display a table with all the drivers of the cards it
detected. These drivers are from the NetWare 4.11/IntranetWare CD-
install Symmetrical Multi-processing