HP D7171A - NetServer - LPr Installation Manual page 13

9. After the system loads SERVER.EXE (automatically, as part of the installation
process) at the NetWare prompt, enter the following command:
load Mega3_1x.DSK
10. Continue the installation process.
NetWare 4.10 and HP NetRAID Drivers
1. Use the MS DOS diskettes to create a 20-50 MB DOS partition on drive C.
Format the partition and install the DOS operating system.
2. Use the CD-ROM drivers for DOS and configure the system to have access to
the CD-ROM drive.
3. Insert the HP NetServer Navigator CD in the CD-ROM drive and boot the HP
NetServer.
4. Follow the instructions from the HP NetServer Navigator to configure NetRAID
disk array and create a drivers diskette. The following procedures refer to this
diskette as the "Drivers Diskette".
NOTE Configuring HP NetRAID includes configuring the type of
array you want and initializing the hard drives. However, if
you use the RAID 0 and RAID 1, you do NOT have to
initialize the drives.
5. Remove the HP NetServer Navigator CD-ROM and insert the NetWare 4.10
CD-ROM.
6. Boot the system into DOS.
7. Insert the Driver Diskette in drive A and copy the HP NetRAID drivers to the
NWSERVER boot directory by entering the following command:
C:\ COPY A:\NetRAID\*.* C:\NWSERVER
8. Follow the NetWare 4.10 Installation and Upgrade documentation to install
NetWare.
9. At the "Choose the Server Drivers - Disk Driver " screen, press the Alt and
Esc keys simultaneously to go to the NetWare command line
10. Manually load the NetRAID drivers by entering one of the following
commands:
Load MEGA4_XX.HAM
or
Load MEGA4XX.DSK
NOTE You must manually load the drivers from the command
line. Using the Install utility will fail to load the HP
NetRAID drivers.