H/W Diagnostic - Addonics Technologies HDUSI325 User Manual

Press ENT again and the LCD will prompt you to con rm the er ase operation.
Quick Erase HDD
This function is used to quickly erase all data on the HDD . Please backup any important data
before using this function.
Press ENT to enter the following screen. Use the Up and Down buttons to select the HDD to
erase.

H/W Diagnostic

Press ENT to enter the following screen. This function is use d to check that the system is
operating normally.
Press ENT again to enter the following screen. The LCD will cycle through the test categories as
they are performed. The LCD display is tested rst, the control panel is tested next (requires
manual operation), then followed by the system's internal diagnostics, hardware connection test
then the RAM and SD Flash test. All test results are shown on the LCD. This is a simple way to
verify that the system is operating normally.
Press ENT and the system will begin the tests as shown below.
LCD Test Start
Test IDE 0/1
OK
Once the system diagnostics have been completed the "Test finished" message will appear on the
LCD.
www.addonics.com
All data will be
lost,Erase? No
10-05.Adv Setup
Quick Erase HDD
Quick Erase HDD
ALL/Target CH:*
11-06.Adv Setup
H/W Diagnostic
Button Test ?
FlashTest: OK
Technical Support (M-F 8:30am - 6:00pm PST)
SDRAM Test:
8192Kbytes OK
Test nished
Phone: 408-453-6212 Email: www.addonics.com/support/query/