Basic System Settings - LevelOne WAB-6120 User Manual

Basic System Settings

For users who use the LEVELONE 150MBPS WIRELESS POE AP for the first time, it is
recommended that you begin configuration from "Basic Settings" in "System" shown below:
Device Name: Specify the device name, which is composed of no more than 15 characters with
(0-9), (A-Z), (a-z) or (-).
Network Mode: Specify the network mode, including Bridge and Router. It is easy to configure
parameters in Bridge Mode; however, users must pay extra attention to the way they configure the
device when it is set to Router Mode. For details, please refer to TCP/IP Settings".
Ethernet Data Rate: Specify the transmission rate of data for Ethernet. Default is Auto.
Country Region: The availability of some specific channels and/or operational frequency bands
is country dependent.
Spanning Tree: Spanning Tree Protocol (STP) is a link management protocol for AP which
provides path redundancy while preventing loops in a network. STP allows only one active path
at a time between the access points but establish the redundant link as a backup if the initial link
fails.
STP Forward Delay: STP Forward Delay is the time spent in detecting and learning network tree
Chapter 3 Basic Settings
Figure 14 Basic System Settings
Page 17