Antenna Alignment; Speed Test - LevelOne WAB-6120 User Manual

Antenna Alignment

Under Bridge mode, when the bridges are not easily visible from the location where the dish will be
installed, the antenna alignment tool can help you evaluate the position of the unit and adjust the angle
of the antenna more precisely. Keep it that in real circumstances a lot of additional factors should be
taken into account when your unit is installed. These factors include various obstacles (buildings, trees),
the landscape, the altitude, transponder orientation, polarization, etc.
To use the tool, select the desired remote WDS bridge and click "Start", the web page will display the
measured signal strength, RSSI and transmit/receive packets. If the signal quality is not quite good, try
to adjust the antenna and see if the quality improves or not.
Figure 30 Antenna Alignment

Speed Test

The speed test is to monitor the current data transmission (TX) and data reception (RX) rate with the
remote LEVELONE 150MBPS WIRELESS POE AP. Enter the IP address of the remote CPE, type in
the user name/password and click "Test". The result will display in the bottom STATUS. You may test
single TX/RX or bi-direction.
Chapter 6 Status Page 51