LevelOne WAB-6120 User Manual page 30

address from a valid DHCP server, it will fall back to default static IP address.
Use Fixed IP Address: Check this option. You have to specify a static IP address, subnet mask,
default gateway and DNS server for the CPE manually. Make sure the specified IP address is
unique on your network in order to prevent IP conflict.
If the LEVELONE 150MBPS WIRELESS POE AP is configured as Router mode, you need to
configure some additional TCP/IP parameters for accessing the Internet.
Figure 16 IP Settings (Router)
WAN Settings: Specify the Internet access method to Static IP, DHCP or PPPOE. Users must
enter WAN IP Address, Subnet Mask, Gateway settings provided by your ISPs.
LAN Settings: When DHCP Server is disabled, users can specify IP address and subnet mask
for the CPE manually. Make sure the specified IP address is unique on your network in order to
prevent IP conflict. When DHCP Server is enabled, users may specify DHCP IP Address Range,
DHCP Subnet Mask, DHCP Gateway and Lease Time (15-44640 minutes). A DHCP relay
agents is used to forward DHCP requests and replies between clients and servers when they are
not on the same physical subnet. To enable the DHCP relay agent, check the "Enable DHCP
Relay" checkbox and enter the IP address of the DHCP server.
Chapter 3 Basic Settings Page 19