LevelOne WAB-6120 User Manual page 37

Disable Wireless LAN Interface
Check this option to disable WLAN interface, then the wireless module of LEVELONE 150MBPS
WIRELESS POE AP will stop working and no wireless device can connect to it.
Wireless Mode
Four operating modes are available in LEVELONE 150MBPS WIRELESS POE AP.
AP: The LEVELONE 150MBPS WIRELESS POE AP establishes a wireless coverage and
receives connectivity from other wireless devices.
Wireless Client: The LEVELONE 150MBPS WIRELESS POE AP is able to connect to the AP
and thus join the wireless network around it.
Bridge: The LEVELONE 150MBPS WIRELESS POE AP establishes wireless connectivity with other APs
by keying in remote MAC address. Please refer to the "WDS Setting" for detailed configuration.
AP Repeater: The LEVELONE 150MBPS WIRELESS POE AP servers as AP and Bridge
concurrently. In other words, the LEVELONE 150MBPS WIRELESS POE AP can provide
connectivity services for CPEs under Bridge mode.
Wireless Network Name (SSID)
This wireless network name is shared among all associated devices in your wireless network.
Keep it identical on all those devices. Note that the SSID is case-sensitive and can not exceed
32 characters.
Broadcast SSID
Under AP mode, hiding network name is necessary when you are in a wireless environment that
may have potential risk. By disabling broadcast SSID, the STA can not scan and find LEVELONE
150MBPS WIRELESS POE AP, so that malicious attack by some illegal STA could be avoided.
802.11 Mode
The LEVELONE 150MBPS WIRELESS POE AP can communicate with wireless devices of
802.11b/g or 802.11b/g/n.
HT Protect
Enable HT (High Throughput) protect to ensure HT transmission with MAC mechanism.
Under 802.11n mode, wireless client can be divided into HT STA and Non-HT STA,
among which the one with HT protect enabled gets higher throughput.
Frequency/Channel
Channel varies much as the available band differs from country to country. Select a proper
Chapter 3 Basic Settings Page 26