LevelOne WAB-6120 User Manual page 112

topology state before entering the forward state. Default time value is 1 sec.
GPS Coordinate Settings
The GPS Coordinate Setting helps you mark the latitude and longitude of the Power R2 Extender.
Just enter the coordinates and click the Apply button.
TCP/IP Settings
Open "TCP/IP Settings" in "System" as below to configure the parameters for LAN which
connects to the LAN port of the CPE. In this page, users may change the settings for IP Address,
Subnet Mask, and DHCP Server.
Obtain IP Address Automatically: If a DHCP server exists in your network, you can check this
option, thus the LEVELONE 150MBPS WIRELESS POE AP is able to obtain IP settings
automatically from that DHCP server.
Note:
When the IP address of the CPE is changed, the clients on the network often need to
wait for a while or even reboot before they can access the new IP address. For an
immediate access to the bridge, please flush the netbios cache on the client computer by
running the "nbtstat –r" command before using the device name of the CPE to access its
Web Management page.
In case the LEVELONE 150MBPS WIRELESS POE AP is unable to obtain an IP
Chapter 3 Basic Settings
Figure 15 IP Settings (Bridge)
Page 18