Lexmark T650 Service Manual page 54

4062
Error
code or
message
201.26
201.27
201.28
201.29
201.30
201.31
2-20
Service Manual
Error contents
Main drive motor
assembly load error.
Type 2 fuser
Sensor (fuser output)
late jam.
Type 2 fuser
Image data did not
start in time
Type 2 fuser
Sensor (narrow
media) late jam
Type 2 fuser
Operator panel door
assembly interlock
switch failure
Type 2 fuser
Sensor (narrow
media) late jam
Type 2 fuser
Description/Action
The main drive motor assembly
has failed or caused high
mechanical load due to paper
jam or bind.
The media is late reaching the
sensor (fuser output) within the
specified time.
Printhead write failure
The expected wide media is
late reaching the sensor
(narrow media) within the
specified time.
The printer detected that the
operator panel door interlock
switch did not cycle prior to
printer restart.
The expected wide media is
late reaching the sensor
(narrow media) within the
specified time.
Possible repair actions
1. Check all connections on
the main drive motor
assembly.
2. Check all connections on
the system card assembly.
3. Replace the main drive
motor assembly if problem
remains. Go to "Output
cover assembly removal
(T650, T652, T654)" on
page 4-54.
Go to sensor (fuser output) late
jam service check.
See "Sensor (fuser output)
late jam service check." on
page 2-135.
If problem remains, a type 2
fuser can be installed.
1. Check all connections on the
printhead assembly
2. Check all connections on the
system card assembly.
3. Replace the printhead
assembly if problem remains.
4. Replace the system card
assembly if problem remains.
Go to "System card
assembly removal (T650,
T652, T654, T656)" on
page 4-76.
Go to sensor (narrow media)
late jam service check.
See "Sensor (narrow media)
late jam service check." on
page 2-139.
1. Remove all media present
in media path.
2. Ensure that the operator
panel door assembly is fully
open then fully closed.
3. Check operator panel door
assembly for damage.
4. Check interlock switch (in
left operator panel hinge)
for damage.
5. Check all connections on
the system card assembly.
Go to sensor (narrow media)
late jam service check.
See "Sensor (narrow media)
late jam service check." on
page 2-139.