Lexmark T430 Service Manual page 62

4048-1xx
Sub error codes (continued)
First 6 bytes sub
error code data
(xx can be any
value)
xx x1
x2
xx x1
x2
xx x1
x2 x3
xx
xx x1
2-28
Service Manual
Explanation
The imaged page is not the expected
page.
(x1=media size, x2=media source)
Check the pass thru sensor to make sure
it is operating properly. If no problem is
found, it may still be necessary to try a
new pass thru sensor.
This code indicates that the media
activated the input sensor before the
printer EP was ready.
(x1=leading edge of media state,
x2=trailing edge of media state)
The transfer servo never started.
(x1=media size, x2=leading edge of
media state, x3=trailing edge state).
Possible causes:
• Slow or missing main motor positional
feedback. Paper too fast to input
sensor.
• Gap too small on interpage servo.
This code indicates that media has
activated the input sensor; however, the
printhead fell out of lock condition or
expected a stable lock too soon. The
media may have also reached the input
sensor early.
Laser servo never started due to potential
conflict with the transfer servo.
(x1=bit 0: transfer servo started,
bit 1: transport started; x2+x3=transfer
servo count value.) Possible cause is slow
or missing transport motor positional
feedback.
Possible
error
message
200
200
200
200
200