Adjusting paper feed alignment (skew)
When a reference feed assembly is removed, it requires
realignment. Use a long shank (6–inches) Phillips screwdriver to
adjust the rear screw holding the assembly in place. It is accessed
through the hole in the main drive assembly. It is between the
controller card cage and the main motor board. Adjust the screw
counterclockwise which rotates paper counterclockwise in the
printer path (image clockwise) and vice versa.
Verify alignment by printing the Quick Test page:
1. Enter the Diagnostic Menu. See
on page 3-2
2. Select Print Tests from the Diagnostic Menu.
3. Select Tray 1.
4. Select Single. The Quick Test prints.
"Entering Diagnostic Mode"
Repair information
4048-1xx
4-5