Network Share Inventory; Pci Bus; Pci Bus Status; Pci Bus Inventory - HP Xw460c - ProLiant - Blade Workstation User Manual

Millisec/Write—The average time required to complete a write operation
Queue Length—The average number of transfer requests (reads and writes) that are waiting to be
serviced by the logical drive

Network Share Inventory

Logical Drive Configuration
Displays the total capacity of the drive
Displays the network storage enclosure in which the selected logical drive is located
Displays the RAID level for this logical drive

PCI bus

The following information is provided for a PCI bus.

PCI Bus Status

MBytes/Sec—The average number of megabytes transferred on the selected PCI bus each second.
PCI Utilization %—The PCI utilization for the selected PCI bus. A 32-bit PCI and 64-bit PCI can operate
simultaneously on the same PCI bus. The utilization is primarily dependent on the MBytes/Sec rate and
the negotiated PCI bus protocol:
32-bit PCI—Operates at 33 MHz, resulting in a maximum throughput of 132 MB/s
64-bit PCI—Operates at 33 MHz, resulting in a maximum throughput of 264 MB/s
64-bit/50-MHz PCI-X—Provides a maximum throughput of 400 MB/s
64-bit/66-MHz PCI or PCI-X—Provides a maximum throughput of 528 MB/s
64-bit/100-MHz PCI-X—Provides a maximum throughput of 800 MB/s
64-bit/133-MHz PCI-X—Provides a maximum throughput of 1064 MB/s
PCI Express X1—Provides a maximum throughput of 500 MB/s
PCI Express X2—Provides a maximum throughput of 1000 MB/s
PCI Express X4—Provides a maximum throughput of 2 GB/s
PCI Express X8—Provides a maximum throughput of 4 GB/s
PCI Express X12—Provides a maximum throughput of 6 GB/s
PCI Express X16—Provides a maximum throughput of 8 GB/s
PCI bus performance is evaluated using the Bus Utilization %.
NOTE: PMP does not accurately report the negotiated PCI bus protocol when unknown PCI devices with
slower transfer rates than the controller are configured on the same bus.

PCI Bus Inventory

PCI Support—Displays the supported and negotiated PCI protocol (bus and speed)
PCI Devices—Lists the PCI bus slots and any I/O expansion boards installed in the slots

Processors

The following information is provided for processors.

Processors Status

Average Processor Utilization %—The average percentage of time that all the processors on the system
are busy executing non-idle threads. On a multiprocessor system, if all processors are always busy, the
metric reads 100%; if all processors are 50% busy, the metric reads 50%; if one-fourth of the processors
PCI bus 161